photo by Loudog99 |
 |
| Author | Comment | ||
|---|---|---|---|
 taniwha2 |
Trying to source a downlock butt cap fitting |
Lead | |
|
Master Guide
Posts: 48 (02/01/09 07:14:41) |
Hi all
I'm after a butt end cap for a downlocker, preferably in black, milled insert type rather than stamped hood. Diameter (ID) 18mm or 23/32 or 24/32ths. Aluminium is fine. Any suggestions? thanks Mark |
||
|
ericzamora |
|||
|
Guide
Posts: 103 (02/07/09 03:55:29) |
it may be outdated but try this source....
http://brooksiderod.tripod.com/components.htm#pbcn eric fresno, ca.
Last Edited By: ericzamora
02/07/09 04:02:26.
Edited 1 times.
|
||
|
taniwha2 |
|||
|
Master Guide
Posts: 51 (02/07/09 05:01:52) |
Thanks Eric
|
||
|
taniwha2 |
|||
|
Master Guide
Posts: 52 (02/08/09 05:31:29) |
I was having a quiet hour of man-time rummaging about in the shed yesterday and noticed a spare dimmer light switch which looked the right size - and it was a
perfect fit! It's only a graphite workhorse rod anyway, so why not... the epoxy is almost set ;-)
|
||
